Replacing the Cam Pocket On Your Ultralight Or Pro Ultralight Repair Stand

Feedback Sports offers a repair solution for worn components on its Ultralight and Pro Ultralight repair stands. The cam pocket, a small internal part in the clamp jaw, can wear out over time, causing the spinner knob to lose tightening grip. The company provides replacement cam pockets and detailed instructions so users can perform the repair themselves in minutes rather than replacing the entire stand.
Key points
- The cam pocket is a critical component inside spinner-knob style clamps. When users spin the tri-knob to tighten the clamp, the threaded rod pulls against this piece to create the clamping function.
- Worn cam pockets cause loss of clamping power and thread slipping. Users can identify the problem when "the spinner knob isn't tightening as smoothly as it used to," according to Feedback Sports.
- Replacement cam pockets are sold separately and cost far less than a new stand. This repair approach aligns with the company's philosophy that "professional-grade tools should be repairable."
- The DIY replacement process requires only basic tools and takes a few minutes. A punch, mallet, flathead screwdriver, and Red Loctite are the primary tools needed for the job.
- Critical safety precaution: do not remove the threaded rod after the stop sleeve is extracted. The internal threads are delicate and may fall out if the rod is separated.
- Feedback Sports provides both video and written step-by-step repair instructions. Users experiencing difficulties can contact the company's technical support team at techsupport@feedbacksports.com.
Summarized by MalakyeAI